Algeria Hospital Bed Remote Control Cable Assembly
The remote control cable assembly of medical remote control beds is usually used to connect the remote control to the control system of the hospital bed, achieving electric adjustment (such as lifting, backboard/leg board Angle, overall tilt, etc.).
Category:
AlgeriaMedical Cable Assembly
Product Description
Remote Control Cable Assembly for Electric Hospital Bed Care Homecare Bed
The remote control cable assembly of medical remote control beds is usually used to connect the remote control to the control system of the hospital bed, achieving electric adjustment (such as lifting, backboard/leg board Angle, overall tilt, etc.). The types, interface types and Pin definitions may vary depending on the design of different brands and models of medical beds, but the following are some common classifications and general standards:
Main Types of Control Cable Assemblies for Medical /Hospital and Home Remote control Beds
Classify by interface type
1. Round aviation plug (commonly found in industrial-grade medical beds)
Model: such as M12, M16, M23, etc. (With threaded locking to prevent detachment).
Pin count: 4 pins, 5 pins, 8 pins, 12 pins, etc.
Pin1 +12V/24V positive terminal of the power supply (depending on the bed type voltage)
Pin2 GND: Power ground
Pin3: Signal A (UP) : Signal for rising/Backplane lifting
Pin4: Signal B (DOWN) : Down/backplane downsignal
Features: Waterproof and dustproof, strong anti-interference ability, often used for remote control cables of high-end hospital beds or operating tables.
2. Rectangular connectors (such as JST, Molex, etc.)
Model: JST XH (2.5mm pitch), JST EH (2.5mm), Molex Mini-Fit, etc.
Pin count: 4 pins to 10 pins, commonly found in the remote control cables of hospital beds with cost advantages.
Pin1 +12V power input
Pin2 :GND
Pin3:Backrest UP
Pin4:Backrest DOWN
Pin5:Legrest UP
Pin6: Legrest DOWN:
Features: Low cost, easy to plug and unplug, but relatively weak protection.
3. DB9 serial port (RS-485/RS-232 communication)
Purpose: Some intelligent hospital beds transmit control signals through serial port communication.
Pin definition: Follow the standard RS-485/232 protocol (such as Pin2-TX, Pin3-RX).
4. Specialized customized interface
Some brands (such as Hill-Rom and Stryker) use proprietary interfaces and require original factory accessories.
Pin1-4: Motor Drive Power supply
Pin5-8: Hall sensor feedback
Pin9-12: CAN bus communication
Jiuchong Industrial Zone, Daning Village, Humen Town, Dongguan , Guangdong 523930, China
